Model name DUCT CUTTER Model name SD-20 Maximum steel plate thickness Mild steel 2.0 mm Stainless steel 1.2 mm Aluminum 2.5 mm Cutting speed 2.1 m/Min Cutting width 5 mm Full load current 400 W Weight 2.2 Kg Features - Since the tool is long, you may work easy at the narrow and deep place - It is possible to cut a shingle plate, a deck plate, a steel deck and a spiral duct and also it can cut the sean part. - The cleaning is easy since the cut scrap is rectangle. Model name DUCT CUTTER Model name SD-16 Maximum steel plate thickness Mild steel 1.6 mm Stainless steel 1.0 mm Aluminum 2.0 mm Cutting speed 2 m/Min Cutting width 5 mm Full load current 400 W Weight 2.2 Kg Features - This is best suitable for air-conditining construction. Decisive - Cutter section is on the same axis with motor section, thus it can be used even in a narrow place. - With the equipped chip receiver, ships do not fall downward even by upward direction work. Thus safes operation can be made. Model name DUCT SHEAR Model name SDS-16 Maximum steel plate thickness Mild steel 1.6 mm Stainless steel 1.0 mm Aluminum 2.0 mm Cutting speed 6.5 m/Min Cutting width 0 mm Full load current 400 W Weight 2.1 Kg Features - It is the first vertical type of the shear in the industry. - It is possible to work in the narrow place as it is the vertical type. - Each of four edges of the blade can be used, the running cost is cheap and the sharpness of the blade is preeminent. - It is possible to cut in right angle, since the minimum cutting radius is small. Since the motor is the small size, it is easy to use. Model name CORD-LESS DUCT SHEAR Model name SD-12 Maximum steel plate thickness Mild steel 1.2 mm Stainless steel 0.8 mm Aluminum 2.0 mm Cutting speed 8 m/Min Cutting width 0 mm Battery Capacity 3000 mAh Weight 2.45 Kg Features - Since it is cordless, operation efficiency rises. - Since the vertical type, you can work also in the narrow place. - Blade can be used on its 4 faces, thus running cost is low, and the sharpness of the blade is preeminent. - Since the minimum radius is small, it is best for the. small-hole cutting.